Near Intersection of I-35 & I-90 Southern Mn. | Not exactly following what you mean by no voltage at flow meter connector. Do you mean on the end that connects to the flow meter or on the flow meter end itself. If there is no voltage at the 3 pin round connector that plugs into the flow meter, then the problem is ahead of that point but beyond the point where the test was good.
If you walked up to a loose flow meter laying on a bench and tested it there would be no voltage present on any combination of pins. There are no batteries or power source inside the flow meter. Its sensor gets its power/ground from the 440.
I believe you are closing in on your problem from both ends and it seems like it would be in between. |