|
northeast ohio | Our planting tractor has an XCN 2050 steering through a NAV3 to SAM 200 motor. We are also running PIQ with 76774-05 Seed Monitoring module and 75774-00 for half width clutches on a ground driven planter. Display is autosync to Farmer Core and using WiFi hotspot for ODOT CORS VRS RTK.
Friday evening when making a turn the XCN 2050 crashed. When it restarted the planter configuration would not load. The issue was the RSCM was not being recognized. The SMM was showing up fine. Checked all of the fuses and even tried swamping the order of the modules on the harnessing. No luck. Since then three other RSCM and SCM module have been tried and none recognized by the display even though all of them had been tested and firmware updated this spring using this same display. Even tried setting up a new implement with only RSCM. No go. So we planted yesterday with SMM only and manually ran the section switches.
Any ideas on a setting that I am overlooking? Or other suggestions?
Edited by neo_ag 4/28/2024 21:01
| |
|