uspsfarmer1 - 5/1/2024 06:56 My 2014 Magnum 210 has the incommand 1200 controlling the steering and also runs the electric drives and monitors seeding performance on the planter. As shopteacher posted, I hijacked the IBBC. Very happy with the performance. Initially, I had trouble calibrating the steering with the agleader. Case blamed "third party equipment", but turned out that the wheel angle sensor was going bad. I had a similar issue with one of them. The tractor was throwing a WAS code when calibrating the Z2. Turns out the CaseIH dealer changed the wheel spacing from 60" or 80" to 88" and adjusted the steering stops before delivery but did not re calibrate the WAS. Once I figured this out and re calibrated it through the Pro 1200 everything went fine. To add to my earlier post, When just the SteerCommand Z2 is hooked to the tractor, the Pro 1200 is still the only ISOBUS display on the CAN, so and implement will show up there, and there only. To get ISOBUS to the InCommand, you need to connect the 6-pin ISO connector on the Ag Leader display cable to the IBBC, preferably with a hi-jack setup to avoid conflicts on the BUS having two displays. | 
Case Magnum running Ag Leader
