![](/profile/get-photo.asp?memberid=109&type=profile&rnd=229)
| BLKCOW - 6/5/2024 11:40 Might not apply, but made a bracket that slips on a tractor loader bucket for a hydraulic post hole digger. Mounts on the left edge of bucket so I can see what I'm doing. Made hoses long enough to reach couplings in the rear. You couldn't give me a three point digger. Down pressure makes a world of difference, auger turns slow so I can pretty well clean out a hole by shutting auger off and lifting the auger full of dirt out of the hole, backing up a foot or so then spinning the dirt off or simply tapping the auger on the ground.
Hyd drive mounted on any type of loader is 100x better than a pto drive on the 3pt. |