|
Eastern Ontario | Still working on getting this Ontrac2 to work on an Integra. The original ECU is branded Autofarm (Rev A), as are the cables. So far I have tried
--3 Integras, and 2 new display cables.
--Connected as per this article, with the exception being the power cable does not have the Deutch connector. https://portal.agleader.com/community/s/article/2083?language=en_US
--I tried the cables with an AgLeader Ontrac ECU2 Rev B. The guy I bought it from said it worked on a Versa.
--I have checked all cables for continuity, but since I don't know the pinouts of the connectors to the ECU, I'm not sure they are going to the correct pins.
--CAN cable is 070-104. The round connector to the ecu has continuity on all 8 pins, 4 to the CAN in and 4 to CAN out. There is a terminator on the out branch, continuity between pins 3 and 4 (green and black in Ag Leader world). I tried removing it, same result.
--When it is connected I get a slow flashing green light on the ECU, about 2 second frequency.
Any suggestions, or where I might find cable schematics an pinouts? Thanks!
Edited by superfarmer 6/12/2024 10:43
| |
|
Ontrac2 to Integra with Autofarm Cables
