|
Michigan Thumb | Coupling a hydraulic drive motor on a dry fert strip til machine to a Trimble IQ rate controller. The hydraulic motor is from precision planting (or a White sticker)
So far my rate controller is talking to the FM 1000 display but when I do the drive calibration it fails. The motor is not turning when giving it hydraulic power. The wiring to the PWM is reading 7.8 volt which I’m told is normal since it pulses. This is during the Drive calibration procedure.
What do I check next to get it run ?
Thanks in advance
----- | |
|
Trimble IQ & Precion Motor Drive
