|
| Thanks for the answers, I don't think I'm asking the right question, or I'm not understanding the answers. I will try to retry my question. I have a small three-point sprayer that was hooked up to an Ez Guide 500 with an Ez steer. I also had a Trimble Ez boom switch. I also had a Raven 440 controller controlling the rate and everything worked well. I have a second tractor I want to use with the three-point sprayer. I have installed an FM750 with an EZ pilot. I want to use the field iq system with this setup. I have wired it up like the diagram above because I would like to plug it into the raven harness going to the sprayer. It looks like I'm doing it wrong. I assumed the sprayer switches and RSCM would get power from the 750, I don't know which is the 16-pin connector where I could add power.
Thanks again
Edited by gw73 6/24/2024 12:57
| |
|