Bottom of the Mitten | JAnderson - 6/29/2024 10:27
Ohm out wiring or just replace with new wires again. Use new connectors for the lights as well
Do not do this. #1 the new wiring is fine unless you somehow damaged it during install. #2 an ohm meter will trick you on a poor connection. You need to load the wire with amps such as a non-LED light bulb. Double check and make 100% certain the wiring is correct. If you're going off what someone else else has previously cobbled up there's a good chance they had it wrong |
Stock trailer wiring day 11?? Beyond frustrated
